We are manufacturing a premium range of POLO
FRP Cooling Tower by using technically advanced mechanism to improve the
quality of products. Made from quality approved raw materials, these are
known for their compact design, corrosion resistance and ease of
maintenance. Our collection is capable to render the varied requirements of
various areas such as chemical plants, power stations, oil refineries and
POLO FRP induced draft round bottle shaped Cooling towers ranging from 5 TR
to 500 TR capacities.
In FRP cooling towers production a special composition of raw materials are
selected to withstand corrosion, to resist water borne bacteria's and
organisms & is light in weight which permits roof installation with
special reinforcement of any kind. Vertical induced draft counter-flow
design permits installation in any direction with freedom. It consumes less
power (energy) overall because of less area.
Cooling Tower Casing is made of selected grade materials of
tough Fibre Glass Reinforced Polyester & resins, etc. Additional
embossing is done for extra strength in case of big cooling towers.
Honeycomb & ring type P.V.C fills are used for extended
contact area having a high heat transfer efficiency. The crossing of air &
water streams in close proximity which creates a diffused turbulence
conducive to evaporation & efficient heat transfer.
Water Basin :
It is completely leak proof which avoids spillage &
seepage of water. It is of deep sump design to ensure maximum water level at
all times & made up of FRP with additional stiffening to take care of
extra water weight. However RCC basin is recommended for capacities 300TR
Specially designed rotary sprinkler head is made of
aluminium alloy to avoid corrosion, also fitted with sealed ball bearings to
take care of thrust & radial loads. S.S. & Brass sprinklers are also
provided at an extra cost.
Fan cast aluminium alloy fan is of aero dynamic designed
axial flow type to achieve high efficiency. FRP fan set can also be supplied
on request at extra cost.
Drift Eliminator :
To reduce carry out losses through entrainment
of moisture drops in the stream by specially designed multiblade rotary
drift eliminator made of FRP sheets/aluminium. Additional PVC eliminator is
provided in large capacity cooling towers.
Special low RPM totally enclosed motors of Vertical, Flange
type with enlarged & threaded shaft and sealed top is supplied with the
cooling tower. The motor is also weather proof and in IP-55 construction.
Supports & Hardware :
All components like tower supports, motor
supports, leg supports, etc. are either hot dip galvanised or epoxy coated.
Hardware is Galvanised Steel.
Stainless Steel or Phosphor Bronze hardwares can be supplied on request at
Dimensional & other engineering data available with
Data required for optimal selection:
In order to facilitate our clients, we also offer following services:
- Rate of water circulation
- Water inlet temperature - °C
- Water outlet temperature - °C
- Ambient wet bulb temperature - °C
- Also information in brief about site conditions and water quality.
- Emergency repairs
- Scheduled maintenance